Deployment Guide

acl_name word Enter the acl_name word , up to 140 characters, for specified access-list.
interface
interface
Enter the keyword interface then the one of the following keywords and slot/
port or number information:
● For a Port Channel interface, enter the keyword port-channel and then
enter a number. The C-Series and S-Series range is from 1 to 4096.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet and then enter the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE and then
enter the slot/port information.
● For a VLAN interface, enter the keyword VLAN followed by the vlan id.
● For a PE Gigabit Ethernet interface, enter the keyword peGigE then the pe-id/
stack-unit/ port-id information.
● For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the
port-id range is 25 to 28 or 49 to 52 depending on the PE.
in Display information of L2 ingress access-list configured to an interface.
out Display information of L2 egress access-list configured to an interface.
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.4.1.0 Introduced.
Usage
information
This command displays ingress or egress L2 access-list information based on a given option.
If no ingress or egress access-list is attached to an interface, no information displays and you return to
the DELL# prompt.
Example
Dell#show mac access-lists in
Standard mac access list m1
seq 5 permit 11:22:33:44:55:66 count (0 packets)
Standard mac access list m2
seq 5 deny any order 2
seq 10 permit 00:33:00:11:00:77 33:44:55:66:77:88 count (0 packets)
Extended mac access list m3
seq 5 permit host 11:11:11:11:11:11 host 22:22:22:22:22:22 snap eq
600
Dell#
Dell#show mac access-lists out
Standard mac access list m1
seq 5 permit 11:22:33:44:55:66 count (0 packets)
Standard mac access list m2
Access Control Lists (ACL) 263