Deployment Guide

in (OPTIONAL) Enter the keyword in to activate only inbound policies.
out (OPTIONAL) Enter the keyword out to activate only outbound policies.
NOTE: You must execute the clear ip bgp soft out command when
ever there is a change in the local policy. If you do not run this command
after a local policy change, then these policy changes are not reflected in the
responses to the peer’s route refresh messages.
dampening Enter the keyword dampening to clear the flap dampening information.
flap-statistics Enter the keywords flap-statistics to clear the flap statistics information.
ipv4 Enter the ipv4 address family to clear.
ipv6 Enter the ipv6 address family to clear.
peer-group Enter the peer-group to clear all members of the peer-group.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
6.5.1.0 Expanded to include the as-number option.
Related
Commands
bgp recursive-bgp-next-hop — disables next-hop resolution through other routes learned by the BGP.
clear ip bgp dampening
Clear information on route dampening and return the suppressed route to the Active state.
C9000 Series
Syntax
clear ip bgp [vrf vrf-name] [ipv4 [multicast | unicast] | ipv6 unicast]
[dampening [ipv4-address mask | ipv6–address mask]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to clear
information on route dampening corresponding to that VRF
NOTE: You can use this attribute on a specific VRF to remove history routes
corresponding to that VRF. You can also use this attribute to return the
suppressed routes corresponding to a specific VRF to an active state.
346 Border Gateway Protocol