Deployment Guide

O - OpenFlow Controller Port-channel
A - Auto Port-channel
I - Internally Lagged
LAG Mode Status Uptime Ports
1 L3 down 00:00:00 Te 11/1 (Down)
Related
Commands
show lacp — displays the LACP matrix.
show port-channel-flow
Display an egress port in a given port-channel flow.
C9000 Series
Syntax
show port-channel-flow outgoing-port-channel number incoming-interface
interface {source-ip address destination-ip address} | {source-port number
destination-port number} | {src-mac address dest-mac address {vlan vlanid |
ether-type}}
Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel then the number of the port
channel to display flow information.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
incoming-
interface
interface
Enter the keywords incoming-interface then the interface type and slot/port
or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Gigabit Ethernet interface, enter the keyword gigabitethernet then
the slot/port information.
● For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE
then the peid/stack-unit/port-pipe id information.
●
For a port extender 10-Gigabit Ethernet interface, enter the keyword
peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range
is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the
port-id range is 25 to 28 or 49 to 52 depending on the PE.
NOTE: The peGigE or peTenGigE option is available only when the extended
bridge feature is enabled.
source-ip
address
Enter the keywords source-ip then the IP source address in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP destination address in IP
address format.
source-port
number
Enter the keywords source-port then the source port number. The range is
from 1 to 65536. The default is None.
destination-port
number
Enter the keywords destination-port then the destination port number. The
range is from 1 to 65536. The default is None.
source-mac
address
Enter the keywords source-mac then the MAC source address in the
nn:nn:nn:nn:nn:nn format.
destination-mac
address
Enter the keywords destination-mac then the MAC destination address in the
nn:nn:nn:nn:nn:nn format.
Interfaces 793