Administrator Guide

show running-config lldp
Display the current global LLDP configuration.
C9000 Series
Syntax
show running-config lldp
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S8420T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell#show running-config lldp
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
hello 15
multiplier 3
no disable
Dell#
snmp-notification-interval
Used to configure the value for the lldp notification interval, to throttle lldp notification messages.
Syntax
[no] snmp-notification-interval [seconds]
To disable this feature, use the no snmp-notification-interval command.
Parameters
seconds Enter a value from 5 to 3600 seconds.
Defaults 5 seconds
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(2.5) Introduced on the S3048–ON, S4048–ON, S4048T-ON, S6010–ON and Z9100–ON
Link Layer Discovery Protocol (LLDP) 1061