Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1121

Table Of Contents

hop–limit

Enable the verification of the advertised hop count limit. If this command is not configured, the verification process is bypassed.

Syntax

hop-limit {maximum | minimum limit}

To reset the hop count limit, use the no hop-limit {maximum | minimum limit} command.

Parameters

maximum

limit

Enter the keyword maximum then the hop limit value. The range is from 0 to 254.

minimum

limit

Enter the keyword minimum then the hop limit value. The range is from 0 to 254.

Defaults None

Command Modes POLICY LIST CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.11(0.0) Introduced on the C9010.

9.9(0.0) Introduced on the Z9500.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9000

switches.

Commands

● ipv6 nd ra-guard enable — configure the RA guard related commands.

● ipv6 nd raguard policy policy-name — define the RA guard policy name and enter the RA guard policy

configuration mode.

ipv6 nd ra–guard attach–policy

Apply the IPv6 RA guard to a specific interface.

Syntax

ipv6 nd ra-guard attach—policy policy-name [vlan [vlan 1, vlan 2, vlan

3.....]]

Parameters

policy

policy-

name

Enter the keyword policy then the policy name. The policy-name allows a

maximum of 140 characters.

vlan

[vlan 1, vlan

2, vlan 3........]

Enter the keyword vlan then the VLAN range. The VLAN range is from 1 to 4094.