Administrator Guide

Version Description
7.6.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
dot1x tx-period
Configure the intervals at which EAPOL PDUs the Authenticator PAE transmits.
C9000 Series
Syntax
dot1x tx-period seconds
To return to the default, use the no dot1x tx-period command.
Parameters
seconds Enter the interval time, in seconds, that EAPOL PDUs are transmitted. The range is
from 1 to 65535. The default is 30.
Defaults 30 seconds
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
mac
Configure a list of supplicant MAC addresses for dot1x profile represented with a profile-name.
Syntax
[no] mac {mac-address1 mac-address2… mac-address6}
Parameters
mac-address1
mac-address2 …
mac-address6
Enter the keyword mac and type the 48– bit MAC addresses using the H.H.H
format. A maximum of 6 MAC addresses are allowed.
Defaults None
Command Modes
DOT1X PROFILE CONFIG (conf-dot1x-profile)
CONFIGURATION TERMINAL BATCH
210 802.1X