Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

371

372

373

374

375

376

377

378

379

380

Table Of Contents

peer-group-name

Enter the name of the peer group to disable or enable all routers within the peer

group.

Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)

Command Modes ROUTER BGP

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.7.1.0 Introduced on the C-Series.

Usage

Information

Peers that are enabled within a peer group are disabled when their peer group is disabled.

The neighbor shutdown command terminates all BGP sessions on the BGP neighbor or BGP peer

group. Use this command with caution as it terminates the specified BGP sessions. When a neighbor or

peer group is shut down, use the show ip bgp summary command to confirm its status.

Commands

show ip bgp summary — displays the current BGP configuration.

show ip bgp neighbors — displays the current BGP neighbors.

neighbor soft-reconfiguration inbound

Enable soft-reconfiguration for BGP.

C9000 Series

Syntax

neighbor {ip-address | peer-group-name} soft-reconfiguration inbound

To disable, use the no neighbor {ip-address | peer-group-name} soft-

reconfiguration inbound command.

Parameters

ip-address

Enter the IP address of the neighbor in dotted decimal format.