Administrator Guide

Table Of Contents
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on Ethernet ports that
support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
C9000 Series
Syntax
dcb-map map-name
Parameters
map-name
Enter a DCB map name. The maximum number of alphanumeric characters is 32.
Defaults None. There are no pre-configured PFC and ETS settings on S5000 Ethernet interfaces.
Command Modes CONFIGURATION
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
Usage
Information
A DCB map is a template used to configure DCB parameters and apply them on converged Ethernet
interfaces. DCB parameters include priority-based flow control (PFC) and enhanced traffic selection
(ETS).
To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map command.
Use the dcb-map command to create a DCB map to specify PFC and ETS settings and apply it on
Ethernet ports. After you apply a DCB map to an interface, the PFC and ETS settings in the map are
applied when the Ethernet port is enabled. DCBx is enabled on Ethernet ports by default.
The dcb-map command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the no dcb-map map-name command in Interface
configuration mode.
priority-pgid
Assign 802.1p priority traffic to a priority group in a DCB map.
C9000 Series
Syntax
priority-pgid dot1p0_group-num dot1p1_group-num dot1p2_group-num
dot1p3_group-num dot1p4_group-num dot1p5_group-num dot1p6_group-num
dot1p7_group-num
Parameters
dot1p07_group-
num
Enter the priority group number for each 802.1p class of traffic in a DCB map.
Defaults None
554 Data Center Bridging (DCB)