Administrator Guide

Defaults Disabled
Command Modes INTERFACE VLAN
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the E-Series.
8.2.1.0 Introduced on the C-Series and S-Series.
Related
Commands
arp inspection-trust — specifies a port as trusted so that ARP frames are not validated against the
binding table.
arp inspection-trust
Specify a port or an interface as trusted so that ARP frames are not validated against the binding table.
C9000 Series
Syntax
arp inspection-trust
Defaults Disabled
Command Modes
● INTERFACE
● INTERFACE PORT-CHANNEL
● INTERFACE PORT EXTENDER (conf-if-pegi-pe-id/Unit/Port)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the E-Series.
8.2.1.0 Introduced on the C-Series and S-Series.
Related
Commands
arp inspection — enables dynamic ARP inspection on a VLAN.
Dynamic Host Configuration Protocol (DHCP) 635