Manualshelf

Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9
81828384858687888990
Table Of Contents
Usage
Information
The password is listed in the configuration file; you can view the password by entering the show
running-config ftp command.
Use the ip ftp password command when you use the ftp: parameter in the copy command.
Related
Commands
ip ftp username — sets the user name for the FTP sessions.
ip ftp source-interface
Configure an interface’s IP address as the source IP address for FTP connections.
C9000 Series
Syntax
ip ftp source-interface interface
To delete an interface, use the no ip ftp source-interface interface command.
Parameters
interface
Enter the following keywords and slot/port or number information:
● For Loopback interfaces, enter the keyword loopback then a number from
zero (0) to 16383.
● For a Port Channel interface, enter the keyword port-channel then a
number. The range is from 1 to 128.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a tunnel interface, enter the keyword tunnel.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Control and Monitoring 81