CLI Guide

clear ip bgp peer-group
Reset a peer-group’s BGP sessions.
S6000
Syntax
clear ip bgp [vrf vrf-name] peer-group peer-group-name [ipv4 [multicast |
unicast] | ipv6 unicast] [soft {in | out}]
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to reset the peer group
corresponding to that VRF.
NOTE: You can use this attribute on a specific VRF to remove history routes
corresponding to that VRF. You can also use this attribute to return the
suppressed routes corresponding to a specific VRF to an active state.
peer-group-name Enter the peer group name to reset the BGP sessions within that peer group.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to
reset ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to reset
ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to reset
ipv6 unicast routes.
soft (OPTIONAL) Enter the keyword soft to reset soft configuration.
in Enter the keyword in to re-configure soft inbound updates.
out Enter the keyword out to re-configure soft outbound updates.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Border Gateway Protocol 367