Connectivity Guide

Table Of Contents

24 bytes successfully copied

DellEMC#

DellEMC#copy tftp://10.16.127.35/username/dv-maa-test ?

flash: Copy to local file system ([flash://]filepath)

nfsmount: Copy to nfs mount file system (nfsmount:///filepath)

running-config remote host:

Destination file name [test.c]:

225 bytes successfully copied

DellEMC#

Save the Running-Configuration

The running-configuration contains the current system configuration. Dell EMC Networking recommends coping your running-

configuration to the startup-configuration.

The commands in this section follow the same format as those commands in the Copy Files to and from the System section

but use the filenames startup-configuration and running-configuration. These commands assume that current directory is the

internal flash, which is the system default.

● Save the running-configuration to the startup-configuration on the internal flash of the primary RPM.

EXEC Privilege mode

copy running-config startup-config

● Save the running-configuration to an FTP server.

EXEC Privilege mode

copy running-config ftp:// username:password@{hostip | hostname}/filepath/ filename

● Save the running-configuration to a TFTP server.

EXEC Privilege mode

copy running-config tftp://{hostip | hostname}/ filepath/filename

● Save the running-configuration to an SCP server.

EXEC Privilege mode

copy running-config scp://{hostip | hostname}/ filepath/filename

NOTE: When copying to a server, a host name can only be used if a DNS server is configured.

NOTE: When you load the startup configuration or a configuration file from a network server such as TFTP to the

running configuration, the configuration is added to the running configuration. This does not replace the existing running

configuration. Commands in the configuration file has precedence over commands in the running configuration.

Configure the Overload Bit for a Startup Scenario

For information about setting the router overload bit for a specific period of time after a switch reload is implemented, see the

Intermediate System to Intermediate System (IS-IS) section in the Dell Command Line Reference Guide for your system.

Viewing Files

You can only view file information and content on local file systems.

To view a list of files or the contents of a file, use the following commands.

● View a list of files on the internal flash.

EXEC Privilege mode

dir flash:

● View the running-configuration.

EXEC Privilege mode

show running-config

● View the startup-configuration.

Getting Started