Glossary

operator Enter one of the following logical operand:
● eq(equal to) — matches packets that contain a ttl value that is equal to the
specified ttl value.
● neq(not equal to) — matches packets that contain a ttl value that is not equal
to the specified ttl value.
● gt(greater than) — matches packets that contain a ttl value that is greater
than the specified ttl value.
● lt (less than) — matches packets that contain a ttl value that is less than the
specified ttl value.
● range(inclusive range of values) — matches packets that contain a ttl value
that falls between the specified range of ttl values.
count (OPTIONAL) Enter the keyword count to count the packets.
bytes (OPTIONAL) Enter the keyword bytes to count the bytes.
log (OPTIONAL) Enter the keyword log to enter ACL matches in the log.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DSCP values. The range
is from 0 to 63.
ecn (OPTIONAL) Enter the keyword ecn to match to the ECN values. The range is
from 0 to 3.
order (OPTIONAL) Enter the keyword order to specify the QoS order for the ACL
entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the
lowest; lower-order numbers have a higher priority). If you do not use the keyword
order, the ACLs have the lowest order by default (255).
monitor (OPTIONAL) Enter the keyword monitor then the session–ID to describe the
traffic that you want to monitor and the ACL in which you are creating the rule is
applied to the monitored interface. The session–ID range is from 0 to 65535.
NOTE: For more information, see “Flow-based Monitoring” in the Port
Monitoring section of the Dell EMC Networking OS Configuration Guide.
fragments Enter the keyword fragments to use ACLs to control packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced the ttl parameter.
9.11(2.0P0) Included support for using logical names of a protocol to configure an IP access list
in both TCP and UDP on the S6000, S6000–ON, S6100–ON, Z9100–ON.
9.11(0.0) Added support for session–ID to the monitor parameter.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
Access Control Lists (ACL) 221