Glossary

Version Description
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the
DCBX configuration on a port, use the show interface dcbx detail command.
If you use the auto-upstream option and the port does not come up on a switch from a different
vendor, manually configure the version a CEE on the peer device.
dcbx version
Configure the DCBX version used on the interface.
Syntax
dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBX version, use the dcbx version {auto | cee | cin | ieee-v2.5}
command.
Parameters
auto | cee | cin |
ieee-v2.5
Enter the DCBX version type used on the interface, where:
● auto: configures the port to operate using the DCBX version received from a
peer.
● cee: configures the port to use CDD (Intel 1.01).
● cin: configures the port to use Cisco-Intel-Nuova (DCBX 1.0).
NOTE: For CIN, priority-group/traffic-class group wise bandwidth works
and priority wise bandwidth configuration is ignored.
● ieee-v2: configures the port to use IEEE 802.1az (Draft 2.5).
Defaults Auto
Command Modes INTERFACE PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the
DCBX configuration on a port, use the show interface dcbx detail command.
Data Center Bridging (DCB) 507