Setup Guide

network
Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this command.
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameters
ip-address Specify an IP network address in dotted decimal format. You cannot specify a
subnet.
Defaults No RIP network is configured.
Command Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address the network command specifies.
offset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
Syntax
offset-list prefix-list-name {in | out} offset [interface]
To delete an offset list, use the no offset-list prefix-list-name {in | out} offset
[interface] command.
Routing Information Protocol (RIP) 1295