Setup Guide

vrf instance (Optional) E-Series Only: Enter the keyword vrf then the VRF Instance name.
ip-address Enter the IP address of the device in dotted decimal format.
ipv6-address Enter the IPv6 address, in the x:x:x:x::x format, to which you are testing
connectivity.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Defaults
● Timeout = 5 seconds
● Probe count = 3
● 30 hops max
● 40 byte packet size
● UDP port = 33434
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series with IPv6.
8.1.1.0 Introduced on the E-Series (IPv4 only).
7.9.1.0 Introduced VRF.
7.6.1.0 Added support for the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for IPv6 address on the E-Series.
E-Series Original command.
Usage
Information
When you enter the traceroute command without specifying an IP address (Extended Traceroute),
you are prompted for a target and source IP address, timeout (in seconds) (default is 5), a probe count
(default is 3), minimum TTL (default is 1), maximum TTL (default is 30), and port number (default is
33434). To keep the default setting for those parameters, press the ENTER key.
For IPv6, you are prompted for a minimum hop count (default is 1) and a maximum hop count (default is
64).
Control and Monitoring 153