Setup Guide

Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Added the multi-auth option on the C-Series and S-Series.
8.3.2.0 Added the single-host and multi-host options on the C-Series, E-Series,
and S-Series.
Usage
Information
● Single-host mode authenticates only one host per authenticator port and drops all other traffic on the
port.
● Multi-host mode authenticates the first host to respond to an Identity Request and then permits all
other traffic on the port.
● Multi-supplicant mode authenticates every device attempting to connect to the network on the
authenticator port.
Related
Commands
● show dot1x interface — display the 802.1X configuration of an interface.
mac
Configure a list of supplicant MAC addresses for dot1x profile represented with a profile-name.
Syntax
[no] mac {mac-address1 mac-address2… mac-address6}
Parameters
mac-address1
mac-address2 …
mac-address6
Enter the keyword mac and type the 48– bit MAC addresses using the H.H.H
format. A maximum of 6 MAC addresses are allowed.
Defaults None
Command Modes
DOT1X PROFILE CONFIG (conf-dot1x-profile)
CONFIGURATION TERMINAL BATCH
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3148.
166 802.1X