Setup Guide

boot zero
Erase the configured primary, secondary, or default boot image parameters. If you erase all three parameters, the S6000 switch
boots from its internal Flash.
Syntax boot zero {primary | secondary | default}
Parameters
primary
Enter the keyword primary to remove the primary boot parameter.
secondary
Enter the keyword secondary to remove the secondary boot parameter.
default
Enter the keyword default to remove the default boot parameter.
Defaults None
Command Modes BOOT_USER
Command
History
Version Description
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Usage
Information
This command reverses changes made with the boot change command.
BOOT_USER # boot zero primary
BOOT_USER # boot zero secondary
BOOT_USER # boot zero default
BOOT_USER # show bootvar
PRIMARY OPERATING SYSTEM BOOT PARAMETERS:
========================================
No Operating System boot parameters specified!
SECONDARY OPERATING SYSTEM BOOT PARAMETERS:
==========================================
No Operating System boot parameters specified!
DEFAULT OPERATING SYSTEM BOOT PARAMETERS:
========================================
No Operating System boot parameters specified!
BOOT_USER #
Related
Commands
boot_change— Change the primary, secondary, or default boot image configuration.
default-gateway
Assign an IP address as the default gateway for the system.
Syntax
[no] default-gateway ip-address
328 Boot Command Line Interface