Setup Guide

ip igmp snooping querier
Enable IGMP querier processing for the VLAN interface.
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, use the no ip igmp snooping querier
command.
Defaults Not configured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
This command enables the IGMP switch to send General Queries periodically. This behavior is useful when
there is no multicast router present in the VLAN because the multicast traffic is not routed. Assign an IP
address to the VLAN interface for the switch to act as a querier for this VLAN.
show ip igmp snooping groups
Display snooping related information for all the IGMP groups, interface or one group of one interface.
Syntax
show ip igmp snooping groups [group-address [detail] | detail | interface
[group-address [detail]]]
Parameters
snooping Enter the keyword snooping to display snooping related information.
Internet Group Management Protocol (IGMP) 639