Setup Guide

Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the platforms S4048–ON, S6100–ON, Z9100–ON, S4048T-ON,
S3048–ON, S6000, S6010–ON, S5048F-ON, FN-IOM, and MXL.
9.13(0.2P2) Introduced on the S3100.
Usage
Information
Whenever the Err-disable recovery timer is reconfigured, it will get effective only after the current timer
expires. Following message is displayed after each Err-disable recovery timer configuration:
DellEMC(conf)# errdisable recovery interval 30
New timer interval will be effective from the next timer instance only.
Related
Commands
errdisable recovery cause — Enable automatic recovery of an interface from the error disabled state.
fec default
Set the FEC to default value.
Syntax
fec default
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Related
Commands
fec enable — enables FEC on the interface.
fec enable
Enable FEC on the interface.
Syntax
fec enable
To disable FEC, use the no fec enable command.
Defaults Enabled on 25G and 50G interfaces
Command Modes INTERFACE
652 Interfaces