Setup Guide

no ip address
switchport
no shutdown
DellEMC(conf-if-range-te-1/1/1-1/1/2)#
show interfaces
Display information on a specific physical interface or virtual interface.
Syntax
show interfaces interface-type[—range]
Parameters
interface Enter one of the following keywords and the interface information:
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For stack-units, enter the keywords stack-unit then the slot/port
information.
● For a Null interface, enter the keyword null then the Null interface number.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port/subport information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a tunnel interface, enter the keyword tunnel then the tunnel ID. The
range is from 1 to 16383.
NOTE: This command also enables you to view information corresponding to
a range of ports. However, for Open Networking (ON) platforms the notation
for specifying port range in the command is different from how you specify in
non-ON platforms.
-range (Optional) Enter the range of interfaces for which you want to view the
information. The format is interface-type slot/port/[subport]-slot/
port/[subport]
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.3) Included the FEC types in the output for 25G, 50G, and 100G interfaces of the
Z9100–ON.
9.14(0.0) Included the FEC counter details in the output for 25 and 50G interfaces of the
S5048–ON.
9.12(1.0) Introduced on the S5048F–ON.
9.12(0.0) Added the OUI value in the command output for the Z9100–ON.
9.11(0.0)
Included the FEC BER details in the output for 100G interfaces of S6100–ON and
Z9100–ON.
Interfaces 681