Setup Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
To fully enable DNS, also specify one or more domain name servers with the ip name-server
command.
Dell EMC Networking OS does not support sending DNS queries over a VLAN. DNS queries are sent out
all other interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related
Commands
● ip name-server — specify a DNS server.
● show hosts — view the current bindings.
ip domain-name
Configure one domain name for the switch.
Syntax
ip domain-name name
To remove the domain name, use the no ip domain-name command.
Parameters
name Enter one domain name to be used to complete unqualified names (that is,
incomplete domain names that cannot be resolved).
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
IPv4 Routing 741