Setup Guide

this command for routed packed only. For switched packets, use the show port-channel-flow
command.
The show ip flow command does not compute the egress port information when load-balance
mac hashing is also configured due to insufficient information (the egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP route table.
Example
DellEMC# show ip flow interface te 1/4/1 20.1.1.1 100.1.1.2 protocol tcp
Flow: 20.1.1.1 100.1.1.2 6
Ingress interface: Te 1/4/1
Egress Interface: Te 1/5/2
DellEMC#
show ip interface
View IP-related information on all interfaces.
Syntax
show ip interface [interface | brief] [configured]
Parameters
interface (OPTIONAL)
Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port/subport information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a Null interface, enter the keyword null then the Null interface number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a stack-unit interface, enter the keyword stack-unit then the stack unit
number.
● For a tunnel interface, enter the keyword tunnel then the tunnel interface
number. The range is from 1 to 16383.
brief
(OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces
and whether an IP address is assigned.
configured (OPTIONAL) Enter the keyword configured to display the physical interfaces
with non-default configurations only.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
770 IPv4 Routing