Setup Guide

Field Description
● C = connected
● S = static
● R = RIP
● B = BGP
● IN = internal BGP
● EX = external BGP
● LO = Locally Originated
● O = OSPF
● IA = OSPF inter area
● N1 = OSPF NSSA external type 1
● N2 = OSPF NSSA external type 2
● E1 = OSPF external type 1
● E2 = OSPF external type 2
● i = IS-IS
● L1 = IS-IS level-1
● L2 = IS-IS level-2
● IA = IS-IS inter-area
● * = candidate default
● > = non-active route
● + = summary routes
The weight for weighted ECMP route calculations is displayed for each path in
the route in show ip route command. The ECMP weight is displayed only if
weighted ECMP is enabled using the ip ecmp weighted command is enabled.
If weighted ECMP is disabled, the show ip route command does not show the
weighted ECMP route information.
Destination
Identifies the route’s destination IP address
Gateway Identifies whether the route is directly connected and on which interface the route
is configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
Example
DellEMC# show ip route all
Codes:C- connected, S - static, R - RIP
B- BGP, IN - internal BGP, EX - external BGP, LO - Locally
Originated
O- OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1
N2- OSPF NSSA external type 2, E1 - OSPF external type 1
E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1
L2- IS-IS level-2, IA - IS-IS inter area, * - candidate default
>- non-active route + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 3.0.0.0/8 via 100.10.10.10, Te 1/8/1 120/1 00:07:12
via 101.10.10.10, Te 1/8/2
100.10.10.0/24 Direct, Te 1/8/1 0/0 00:08:54
> R 100.10.10.0/24 Direct, Te 1/8/2 120/0 00:08:54
C 101.10.10.0/24 Direct, Te 1/8/1 0/0 00:09:15
> R 101.10.10.0/24 Direct, Te 1/8/2 120/0 00:09:15
DellEMC#
Example
(Summary)
DellEMC# show ip route summary
IPv4 Routing 777