Setup Guide

Version Description
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage
Information
When you use the no tagged command, the interface is automatically placed in the Default VLAN as an
untagged interface unless the interface is a member of another VLAN. If the interface belongs to several
VLANs, remove it from all VLANs to change it to an untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can only belong to one VLAN
at a time.
Related
Commands
● interface vlan — configure a VLAN.
● untagged — specify which interfaces in a VLAN are untagged.
track ip
Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member interfaces.
Syntax
track ip interface
To remove the tracking feature from the VLAN, use the no track ip interface command.
Parameters
interface Enter the following keywords and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port/subport information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
Defaults Not configured.
Command Modes INTERFACE VLAN
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
906 Layer 2