White Papers

set weight
To add a non-RFC compliant attribute to the BGP route to assist with route selection, configure a filter.
Syntax
set weight weight
To delete a weight specification, use the no set weight weight command.
Parameters
weight Enter a number as the weight used by the route meeting the route map
specification. The range is from 0 to 65535. The default is router-originated =
32768 and all other routes = 0.
When there are multiple routes to the same destination, the routes with a higher
weight are preferred.
Defaults router-originated = 32768; all other routes = 0
Defaults Not configured.
Command Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
If you do not use the set weight command, router-originated paths have a weight attribute of 32768
and all other paths have a weight attribute of zero.
show config
Display the current route map configuration.
Syntax
show config
Command Modes ROUTE-MAP
264 Access Control Lists (ACL)