White Papers

Link Layer Discovery Protocol (LLDP)
The link layer discovery protocol (LLDP) advertises connectivity and management from the local station to the adjacent stations
on an IEEE 802 LAN.
LLDP facilitates multi-vendor interoperability by using standard management tools to discover and make available a physical
topology for network management. The Dell EMC Networking operating software implementation of LLDP is based on IEEE
standard 801.1ab.
The starting point for using LLDP is invoking LLDP with the protocol lldp command in either CONFIGURATION or
INTERFACE mode.
The information LLDP distributes is stored by its recipients in a standard management information base (MIB). You can access
the information by a network management system through a management protocol such as simple network management
protocol (SNMP).
Topics:
• LLPD Commands
• LLDP-MED Commands
LLPD Commands
The following are LLDP commands.
advertise dot1-tlv
Advertise dot1 TLVs (Type, Length, Value).
Syntax
advertise dot1-tlv {port-protocol-vlan-id | port-vlan-id | vlan-name}
To remove advertised dot1-tlv, use the no advertise dot1-tlv {port-protocol-vlan-id |
port-vlan-id | vlan-name} command.
Parameters
port-protocol-
vlan-id
Enter the keywords port-protocol-vlan-id to advertise the port protocol
VLAN identification TLV.
port-vlan-id Enter the keywords port-vlan-id to advertise the port VLAN identification
TLV.
vlan-name Enter the keywords vlan-name to advertise the vlan-name TLV. This keyword is
only supported on the C-Series and S-Series.
Defaults Disabled.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
32
Link Layer Discovery Protocol (LLDP) 975