Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1101

Table Of Contents

multiplier

value

Enter the keyword multiplier to specify the number of packets that must be

missed in order to declare a session down. The range is from 3 to 50. The default is

role [active |

passive]

Enter the role that the local system assumes:

● Active — active system initiates the BFD session. Both systems can be active

for the same session.

● Passive — passive system does not initiate a session. It only responds to a

request for session initialization from the active system.

The default is Active.

Defaults See Parameters.

Command Modes INTERFACE

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.2.0.0 Introduced on the Z9000, S4820T, and S4810.

Usage

Information

This command provides the flexibility to fine-tune the timer values based on individual interface needs

when you configure ipv6 ospf BFD in CONFIGURATION mode. Any timer values specified with this

command overrides timers set using the bfd all-neighbors command. Using the no form of this

command does not disable BFD if you configure BFD in CONFIGURATION mode.

To disable BFD on a specific interface while you configure BFD in CONFIGURATION mode, use the

keyword disable.

ipv6 ospf cost

Explicitly specify the cost of sending a packet on an interface.

Syntax

ipv6 ospf interface-cost

Parameters

interface-cost

Enter a unsigned integer value expressed as the link-state metric. The range is from

1 to 65535.

Defaults Default cost based on the bandwidth.