Administrator Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when you configure a virtual IP address.
When you delete the virtual IP address, the VRRP group stops sending VRRP packets.
Related
Command
● virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
version
Set the VRRP protocol version for the IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the no version command.
Parameters
2 Enter the keyword 2 to specify VRRP version 2 as defined by RFC 3768, Virtual
Router Redundancy Protocol.
3 Enter the keyword 3 to specify VRRP version 3 as defined by RFC 5798, Virtual
Router Redundancy Protocol.
both Enter the keyword both for in-service migration from VRRP version 2 to VRRP
version 3.
Defaults 2
Command Modes VRRP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
1664 Virtual Router Redundancy Protocol (VRRP)