Administrator Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Example
DellEMC(conf)# interface range gigabitethernet 1/1 - 1/2
DellEMC(conf-if-range-gi-1/1-2)# show config
!
interface GigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface GigabitEthernet 1/2
no ip address
switchport
no shutdown
DellEMC(conf-if-range-gi-1/1-1/2)#
show hardware
Display the hardware counters on a specified interface or on a specified stack unit.
Syntax
show hardware {counters interface interface—type slot/port | stack-unit
stack-unit-number unit unit-number counters}
Parameters
counters Enter the keyword counters to display the counters on a specified interface.
interface Enter the keyword interface followed by the interface information and the slot/
port number.
stack-unit Enter the keyword stack-unit followed by a stack unit-number to display the
counters on a specified stack unit.
unit Enter the keyword unit followed by a unit-number.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced on the S3048–ON.
640 Interfaces