Administrator Guide

● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a Null interface, enter the keyword null then the Null interface number.
● For a tunnel interface, enter the keyword tunnel then the tunnel interface
number. The range is from 1 to 16383.
● For a VLAN interface, enter the keyword VLAN then the vlan number. The
range is from 1 to 4094.
If you configure a static IPv6 route using an egress interface and enter the ping
command to reach the destination IPv6 address, the ping operation may not work.
Configure the IPv6 route using a next-hop IPv6 address in order for the ping
command to detect the destination address.
ipv6-address (OPTIONAL) Enter the forwarding router IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
distance (OPTIONAL) Enter a number as the metric distance assigned to the route. The
range is from 1 to 255.
name description (OPTIONAL) Enter the keyword name and the description for the IPv6 static route
configuration.
tag value (OPTIONAL) Enter the keyword tag then a tag value number. The range is from 1
to 4294967295.
permanent (OPTIONAL) Enter the keyword permanent to specify that the route is not to be
removed, even if the interface assigned to that route goes down.
NOTE: If you disable the interface with an IPv6 address associated with the
keyword permanent, the route disappears from the routing table.
weight weight-
value
Enter the keyword weight followed by a weight value. The range is from 0 to 255.
NOTE: Weight for a static route can be added only for the destination address
and not for the route pointing to destination a interface.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.2) Added the keyword name for static routes.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Also included the weight parameter to support weighted
ECMP feature. Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
782 IPv6 Basics