Administrator Guide

table entry. The switch creates only one entry per VLAN in the forwarding table for each multicast group, for which it snoops an
MLD report.
clear ipv6 mld snooping groups
Clear entries from the group cache table.
Syntax
clear ipv6 mld snooping groups [interface | group-address]
Parameters
interface Enter the following keywords and slot/port or number information:
● For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
● For a Port Channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
group-address (OPTIONAL) Enter the group address in the following format: x:x:x:x::x. The ::
notation specifies successive hexadecimal fields of zero.
Defaults None.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the S3048–ON, S4048–ON, S4048T-ON, S5048F-ON, S6000–ON,
S6010–ON, S6100–ON, Z9100–ON, S3100, and C9010.
debug ipv6 mld snooping
Enable debugging on IPv6 MLD snooping packets.
Syntax
debug ipv6 mld {group-address | interface}
To turn off debugging, use the no debug ipv6 mld {group-address | interface} command.
Parameters
group-address (OPTIONAL) Enter the multicast group address in the x:x:x:x::x format. The ::
notation specifies successive hexadecimal fields of zero.
interface Enter the following keywords and slot/port or number information:
● For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
● For a Port Channel interface, enter the keywords port-channel then a
number.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
Defaults Disabled.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Multicast Listener Discovery Protocol 949