API Guide

monitor multicast-queue
Configure monitor QoS multicast queue ID.
Syntax
monitor multicast-queue queue-id
To remove the configuration, use the no monitor multicast-queue command.
Parameters
queue-id Enter the QoS multicast queue ID. The range is from 0 to 9.
Defaults
queue-id: 0
Enable status: Disabled
Command Modes CONFIGURATION
Example
DellEMC(conf)#monitor multicast-queue 7
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Introduced on the S6000, Z9500, S6000-ON.
Related
Commands
show running-config monitor session — displays information about monitor configurations.
monitor session
Create a session for monitoring traffic with port monitoring.
Syntax
monitor session session-ID [type { rpm | erpm [set ip dscp dscp_value | set
ip ttl ttl_value]}] [drop]
To delete a session, use the no monitor session session-ID command.
To delete all monitor sessions, use the no monitor session all command.
Parameters
session-ID Enter a session identification number. The range is from 0 to 65535.
type Specifies one of the following type:
● rpm
● erpm
rpm Creates a remote port monitoring (rpm) session.
erpm Creates an encapsulated remote port monitoring (erpm) session.
Port Monitoring 1261