CLI Guide

Related
Commands
● arp inspection-trust — specify a port as trusted so that ARP frames are not validated against the
binding table.
arp inspection-limit
Configure dynamic ARP inspection rate-limit to verify the rate of ARP packet received in a port on a specific interval.
Syntax
arp inspection-limit {rate pps [interval seconds]}
Defaults None
Command Modes INTERFACE CONFIGURATION
Parameters
rate pps Enter the keyword rate then the packet per second (pps) value. The range is
from 1 to 2048. The default is 15.
interval seconds (Optional) Enter the keyword intervalthen the burst interval in seconds. The
range is from 1 to 15. The default is 1.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced on the S3048-ON, S4048-ON, S4048T-ON, S3100 Series, Z9100-ON,
S6100-ON, S6000, S6000-ON, S6010-ON, S5048F-ON, S4810, S4820T, FN IOM
and MXL.
arp inspection-trust
Specify a port as trusted so that ARP frames are not validated against the binding table.
Syntax
arp inspection-trust
Defaults Disabled
Command Modes
● INTERFACE
● INTERFACE PORT-CHANNEL
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Dynamic Host Configuration Protocol (DHCP) 549