CLI Guide

Usage
Information
The following describes the show vlan command shown in the following example.
Column
Heading
Description
(Column 1 — no
heading)
● asterisk symbol (*) = Default VLAN
● G = GVRP VLAN
● P = primary VLAN
● C = community VLAN
● I = isolated VLAN
● O = OpenFlow
NUM Displays existing VLAN IDs.
Status Displays the word Inactive for inactive VLANs and the word Active for active
VLANs.
Q
● Displays G for GVRP tagged
● M for member of a VLAN-Stack VLAN
● T for tagged interface
● U for untagged interface
● x (not capitalized x) for Dot1x untagged
● X (capitalized X) for Dot1x tagged
● o (not capitalized o) for OpenFlow untagged
● O (capitalized O) for OpenFlow tagged
● H for VSN tagged
● i (not capitalized i) for Internal untagged
● I (capitalized I) for Internal tagged
● v (not capitalized v) for VLT untagged
● V (capitalized V) for VLT tagged
Ports Displays the type, slot, and port information.
● Po = port channel
● Te = ten-gigabit Ethernet
● Fo = forty-gigabit Ethernet
Example
DellEMC# show vlan
Codes: * - Default VLAN, G - GVRP VLANs, P - Primary, C - Community, I -
Isolated
Q: U - Untagged, T - Tagged, O - Openflow
x - Dot1x untagged, X - Dot1x tagged
o - OpenFlow untagged, O - OpenFlow tagged
G - GVRP tagged, M - Vlan-stack
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT
tagged
NUM Status Description Q Ports
* 1 Inactive
2 Active U Po1(Te 1/1/1)
T Po20(Te 1/6/1), Te 1/25/1
T Te 1/7/1
3 Active T Po20(Te 1/6/1)
T Te 1/7/1
U Te 1/1/1
4 Active U Po2(Te 1/2/1)
T Po20(Te 1/6/1)
T Te 1/7/1
5 Active T Po20(Te 1/6/1)
T Te 1/7/1
U Te 1/3/1
6 Active U Po3(Te 1/4)
T Po20(Te 1/6/1)
T Te 1/7/1
7 Active T Po20(Te 1/6/1)
T Te 1/7/1
892
Layer 2