Deployment Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1651

Table Of Contents

system-mac

Reconfigure the default MAC address for the domain.

Syntax

system-mac mac-address

Parameters

mac-address

Enter the system MAC address for the VLT domain.

Defaults Not configured.

Command Modes VLT DOMAIN

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.10(0.0) Introduced on the S3148.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.5(0.1) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-

Mux (PMUX) mode only.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.8.0 Introduced on the S4810.

Usage

Information

When you create a VLT domain on a switch, the Dell EMC Networking OS automatically creates a

VLT-system MAC address used for internal system operations.

To reconfigure the default MAC address for the domain, use the system-mac command. The MAC

address must be in the nn:nn:nn:nn:nn:nn format. Also reconfigure the same MAC address on the VLT

peer switch.

unit-id

Configure the default unit ID of a VLT peer switch.

Syntax

unit-id [0 | 1]

Parameters

0 | 1 Configure the default unit ID of a VLT peer switch. Enter 0 for the first peer. Enter

1 for the second peer.

Defaults Automatically assigned based on the MAC address of each VLT peer. The peer with the lower MAC

address is assigned unit 0; the peer with the higher MAC address is assigned unit 1.