Deployment Guide

● If you configure sequence-number, the sequence-number is used as a tie breaker for rules with the
same order.
Related
Commands
● deny — configure a filter to drop packets.
● permit — configure a filter to forward packets.
Extended IP ACL Commands
When an ACL is created without any rule and then applied to an interface, ACL behavior reflects an implicit permit.
The following commands configure extended IP ACLs, which in addition to the IP address, also examine the packet’s protocol
type.
The platform supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands sections.
deny
Configure a filter that drops IP packets meeting the filter criteria.
Syntax
deny {ip | ip-protocol-number} {source mask | any | host ip-address}
{destination mask | any | host ip-address} [ttl operator][count [byte] |
log] [dscp value] [order] [monitor] [fragments] [no-drop]
To remove this filter, you have two choices:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● Use the no deny {ip | ip-protocol-number} {source mask | any | host ip-
address} {destination mask | any | host ip-address} command.
Parameters
ip Enter the keyword ip to configure a generic IP access list. The keyword ip
specifies that the access list denies all IP protocols.
ip-protocol-
number
Enter a number from 0 to 255 to deny based on the protocol identified in the IP
protocol header.
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified
in A.B.C.D format, may be either contiguous or noncontiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
ttl Enter the keyword ttl to deny a packet based on the time to live value. The range
is from 1 to 255.
operator Enter one of the following logical operand:
● eq(equal to) — matches packets that contain a ttl value that is equal to the
specified ttl value.
● neq(not equal to) — matches packets that contain a ttl value that is not equal
to the specified ttl value.
● gt(greater than) — matches packets that contain a ttl value that is greater
than the specified ttl value.
● lt (less than) — matches packets that contain a ttl value that is less than the
specified ttl value.
● range(inclusive range of values) — matches packets that contain a ttl value
that falls between the specified range of ttl values.
count (OPTIONAL) Enter the keyword count to count packets that the filter processes.
196 Access Control Lists (ACL)