Deployment Guide

User "admin" on line vty0 ( 123.12.1.123 )
User "admin" on line vty1 ( 123.12.1.123 )
User "Irene" on line vty3 ( 123.12.1.321 )
DellEMC#conf
When another user enters CONFIGURATION mode, Dell EMC Networking OS sends a message similar to the following:
% Warning: User "admin" on line vty2 "172.16.1.210" is in configuration
In this case, the user is “admin” on vty2.
Obtaining Help
As soon as you are in a Command mode, there are several ways to access help:
To obtain a list of
keywords at any
command mode:
Type a ? at the prompt or after a keyword. There must always be a space before the ?.
To obtain a list
of keywords with
a brief functional
description:
Type help at the prompt.
To obtain a list of
available options:
Type a keyword, and then enter a space and a ?.
To obtain a list of
partial keywords
using a partial
keyword:
Type a partial keyword, and then enter a ?.
Example
The following is an example of entering ip ? at the prompt:
DellEMC(conf)#ip ?
access-list Named access-list
as-path BGP autonomous system path filter
community-list Add a community list entry
control-plane Control plane configuration
dhcp DHCP configuration commands
domain-list Domain name to complete unqualified host name
domain-lookup Enable IP Domain Name System hostname translation
domain-name Define the default domain name
ecmp Weighted Ecmp Configuration
ecmp-group ECMP Group Configuration
extcommunity-list Add a Extended community list entry
ftp FTP configuration commands
helper-address DHCP relay agent configuration
host Add an entry to the ip hostname table
http HTTP configuration commands
icmp ICMP configuration commands
igmp Internet Group Management Protocol
max-frag-count Max. fragmented packets allowed in IP re-assembly
mroute Multicast routes and counters
msdp Multicast source discovery protocol
multicast-limit Max entries in Multicast TIB
multicast-msdp Enable IP multicast MSDP protocol
multicast-routing Enable IP multicast forwarding
name-server Specify addess of name server to use
pim Protocol Independent Multicast
prefix-list Build a prefix list
radius Interface configuration for RADIUS
redirect-list Named redirect-list
route Establish static routes
route-export Export routes
route-import Import routes
scp SCP configuration commands
source-route Process packets with source routing header options
ssh SSH configuration commands
tacacs Interface configuration for TACACS+
tcp global tcp settings
telnet Specify telnet options
tftp TFTP configuration commands
unicast-host-route Configuration for ip unicast address-family
unknown-unicast Enable IPv4 unknown-unicast packets to CPU
vlan-flooding Vlan flooding
vrf Configure VRF instance
42
CLI Basics