Install Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced.
Usage
Information
By default, when rate policing and shaping, the system does not include the Preamble, SFD, or the IFG
fields. These fields are overhead; only the fields from MAC destination address to the CRC are used for
forwarding and are included in these rate metering calculations.
service-class bandwidth-percentage
Specify a minimum bandwidth for queues.
Syntax
service-class bandwidth-percentage queue0 number queue1 number queue2
number queue3 number queue4 number queue5 number queue6 number queue7
number
Parameters
number Enter the bandwidth-weight, as a percentage.
Defaults none
Command Modes CONFIGURATION
Command
History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
Usage
Information
Guarantee a minimum bandwidth to different queues globally using the service-class bandwidth-
percentage command from CONFIGURATION mode. The command is applied in the same way as
the bandwidth-percentage command in an output QoS policy. The bandwidth-percentage
command in QOS-POLICY-OUT mode supersedes the service-class bandwidth-percentage
command.
service-class dot1p-mapping
Configure a service-class criterion based on a dot1p value.
Syntax
service-class dot1p-mapping {dot1p0 queue | dot1p1 queue | dot1p2 queue |
dot1p3 queue | dot1p4 queue| dot1p5 queue | dot1p6 queue | dot1p7 queue}
Quality of Service (QoS) 1231