Install Guide

To delete the authentication failure VLAN, use the no dot1x auth-fail-vlan vlan-id [max-
attempts number] command.
Parameters
vlan-id Enter the VLAN Identifier. The range is from 1 to 4094.
max-attempts
number
(OPTIONAL) Enter the keywords max-attempts followed number of attempts
desired before authentication fails. The range is from 1 to 5. The default is 3.
Defaults 3 attempts
Command Modes CONFIGURATION (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Introduced on the C-Series and S-Series.
Usage
Information
If the host responds to 802.1X with an incorrect login/password, the login fails. The switch attempts to
authenticate again until the maximum attempts configured is reached. If the authentication fails after all
allowed attempts, the interface moves to the authentication failed VLAN.
After the authentication VLAN is assigned, the port-state must be toggled to restart authentication.
Authentication occurs at the next reauthentication interval (dot1x reauthentication).
Related
Commands
● dot1x port-control — enable port control on an interface
● dot1x guest-vlan — configure a guest VLAN for limited access users or for devices that are not
802.1X capable.
● show dot1x interface — display the 802.1X configuration of an interface.
dot1x auth-server
Configure the authentication server to RADIUS.
Syntax
dot1x auth-server radius
Defaults None
Command Modes CONFIGURATION
158 802.1X