Install Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1641

Table Of Contents

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-

Mux (PMUX) mode only.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.8.0 Introduced on the S4810.

Usage

Information

After you configure a VLT domain on each peer switch and connect (cable) the two VLT peers on each

side of the VLT interconnect, the system elects a primary and secondary VLT peer device. To configure

the primary and secondary roles before the election process, use the primary-priority command.

Enter a lower value on the primary peer and a higher value on the secondary peer.

If the primary peer fails, the secondary peer (with the higher priority) takes the primary role. If the

primary peer (with the lower priority) later comes back online, it is assigned the secondary role (there is

no preemption).

show vlt brief

Displays summarized status information about VLT domains configured on the switch.

Syntax

show vlt brief

Default Not configured.

Command Modes EXEC

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.