Setup Guide

Parameters
access-list-name Enter the name of a configured access list, up to 140 characters.
Defaults Not enabled.
Command Modes
MONITOR SESSION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced the command under the MONITOR SESSION mode on the S6100–ON,
Z9100–ON, S6000, S6000–ON, and S5048F-ON.
erpm
Configure the source and destination IP address for ERPM traffic.
Syntax
erpm source-ip ip-address dest-ip ip-address [gre-protocol value]
To remove the configuration, use the no erpm source-ip IP-address dest-ip IP-address
[gre-protocol value] command.
Parameters
source–ip ip-
address
Enter the keywords source-ip then the source IP address in dotted decimal
format.
destination–ip
ip-address
Enter the keywords dest-ip then the destination IP address in dotted decimal
format.
gre–protocol
value
(OPTIONAL) Enter the keywords gre-protocol then the protocol type value for
ERPM type monitor session. The range is from 1 to 65535.
Command Modes MONITOR SESSION (conf-mon- sess-session-ID)
Example
DellEMC(conf-mon-sess-10)#erpm source-ip 10.10.10.1 dest-ip 5.1.1.2 gre-
protocol 1111
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.11(0.0) Introduced GRE protocol support.
monitor multicast-queue
Configure monitor QoS multicast queue ID.
Syntax
monitor multicast-queue queue-id
To remove the configuration, use the no monitor multicast-queue command.
Parameters
queue-id Enter the QoS multicast queue ID. The range is from 0 to 9.
Defaults
queue-id: 0
Enable status: Disabled
Command Modes CONFIGURATION
1184 Port Monitoring