Setup Guide

Version Description
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only one of each. Each time
this command is issued, it replaces the previously configured address of the same family, IPv4 or IPv6.
The no virtual-ip command takes an address/prefix-length argument, so that the desired address
only is removed. If you enter the no virtual-ip command without any specified address, then both
IPv4 and IPv6 virtual addresses are removed.
Related
Commands
● ip address — assigns a primary and secondary IP address to the interface.
write
Copy the current configuration to either the startup-configuration file or the terminal.
Syntax
write [memory [compressed] | terminal]
Parameters
memory Enter the keyword memory to copy the current running configuration to the
startup configuration file. This command is similar to the copy running-config
startup-config command.
compressed Enter the keyword compressed to write the operating configuration to the
startup-config file in the compressed mode.
terminal Enter the keyword terminal to copy the current running configuration to the
terminal. This command is similar to the show running-config command.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
Control and Monitoring 149