Setup Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1521

Table Of Contents

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-

MUX (PMUX) mode only.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

7.4.1.0 E-Series Only: Added the percentage decimal value option.

6.5.1.0 Introduced on the E-Series.

Usage

Information

Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast traffic is treated as

unknown-unicast traffic.

storm-control broadcast (Interface)

Configure the percentage of broadcast traffic allowed on an interface (ingress only).

Syntax

storm-control broadcast [packets_per_second in]

To disable broadcast storm control on the interface, use the no storm-control broadcast

[packets_per_second in] command.

Parameters

packets_per_sec

ond

Enter the packets per second of broadcast traffic allowed into the network. The

range is from 0 to 33554368.

Defaults none

Command Modes INTERFACE (conf-if-interface-slot/port)