Setup Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

1641

Table Of Contents

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-

Mux (PMUX) mode only.

9.0.2.0 Introduced on the S6000.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.8.0 Introduced on the S4810.

Usage

Information

The VLT domain ID must be the same between the two VLT devices. If the domain ID is not the same, a

syslog message generates and VLT does not launch.

Commands

● show vlt brief — display the delay-restore value.

vlt-peer-lag port-channel

Associate the port channel to the corresponding VLT peer port channel for the VLT connection to an attached device.

Syntax

vlt-peer-lag port-channel id-number

Parameters

id-number

Enter the respective VLT port-channel number of the peer device. The range is

from 1 to 128.

Defaults Not configured.

Command Modes INTERFACE PORT-CHANNEL

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.