Setup Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

551

552

553

554

555

556

557

558

559

560

Table Of Contents

ip dhcp snooping

Enable DHCP snooping globally.

Syntax

[no] ip dhcp snooping

Defaults Disabled

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.2.(0.0) Introduced on the S4810 and S4820T.

9.0.2.0 Introduced on the S6000.

8.3.11.1 Introduced on the Z9000.

8.3.1.0 Introduced on the E-Series.

8.2.1.0 Introduced on the C-Series and S-Series on Layer 2 interfaces.

7.8.1.0 Introduced on the C-Series and S-Series on Layer 3 interfaces.

Usage

Information

When enabled, no learning takes place until you enable snooping on a VLAN. After disabling DHCP

snooping, the binding table deletes and Option 82, IP Source Guard, and Dynamic ARP Inspection are

disabled.

Introduced in Dell EMC Networking OS version 7.8.1.0, DHCP snooping was available for Layer 3 only and

dependent on DHCP Relay Agent (ip helper-address). Dell EMC Networking OS version 8.2.1.0

extends DHCP Snooping to Layer 2. You do not have to enable relay agent to snoop on Layer 2

interfaces.

ipv6 dhcp snooping

Enable DHCPv6 snooping globally for ipv6.