White Papers

○ map-name: the name of a configured route map.
To view the current RIP configuration, use the show running-config command in EXEC mode or the show config
command in ROUTER RIP mode.
Setting the Send and Receive Version
To change the RIP version globally or on an interface in Dell EMC Networking OS, use the following command.
To specify the RIP version, use the version command in ROUTER RIP mode. To set an interface to receive only one or the
other version, use the ip rip send version or the ip rip receive version commands in INTERFACE mode.
You can set one RIP version globally on the system using system. This command sets the RIP version for RIP traffic on the
interfaces participating in RIP unless the interface was specifically configured for a specific RIP version.
● Set the RIP version sent and received on the system.
ROUTER RIP mode
version {1 | 2}
● Set the RIP versions received on that interface.
INTERFACE mode
ip rip receive version [1] [2]
● Set the RIP versions sent out on that interface.
INTERFACE mode
ip rip send version [1] [2]
To see whether the version command is configured, use the show config command in ROUTER RIP mode.
The following example shows the RIP configuration after the ROUTER RIP mode version command is set to RIPv2. When
you set the ROUTER RIP mode version command, the interface (TenGigabitEthernet 1/1) participating in the RIP
process is also set to send and receive RIPv2 (shown in bold).
To view the routing protocols configuration, use the show ip protocols command in EXEC mode.
DellEMC#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 23
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface Recv Send
TenGigabitEthernet 1/1 2 2
Routing for Networks:
10.0.0.0
Routing Information Sources:
Gateway Distance Last Update
Distance: (default is 120)
DellEMC#
To configure an interface to receive or send both versions of RIP, include 1 and 2 in the command syntax. The command syntax
for sending both RIPv1 and RIPv2 and receiving only RIPv2 is shown in the following example.
DellEMC(conf-if)#ip rip send version 1 2
DellEMC(conf-if)#ip rip receive version 2
Routing Information Protocol (RIP)
755