Administrator Guide

Never apply the permit statement because the redirect list covers all source and destination IP addresses.
ip redirect-list rcl0
seq 5 redirect 2.2.2.2 ip any any
seq 10 permit ip host 3.3.3.3 any
To ensure the permit permit statement or PBR exception is effective, use a lower sequence number, as shown:
ip redirect-list rcl0
seq 10 permit ip host 3.3.3.3 any
seq 15 redirect 2.2.2.2 ip any any
Create a Redirect List
To create a redirect list, use the following commands.
Create a redirect list by entering the list name.
CONFIGURATION mode
ip redirect-list redirect-list-name
redirect-list-name: 16 characters.
To delete the redirect list, use the no ip redirect-list command.
The following example creates a redirect list by the name of xyz.
DellEMC(conf)#ip redirect-list ?
WORD Redirect-list name (max 16 chars)
DellEMC(conf)#ip redirect-list xyz
Create a Rule for a Redirect-list
To set the rules for the redirect list, use the following command. You can enter the command multiple times and create a
sequence of redirect rules. Use the seq nn redirect version of the command to organize your rules.
Configure a rule for the redirect list.
CONF-REDIRECT-LIST mode
seq {number} redirect {ip-address | tunnel tunnel-id} [track <obj-id>}{ip-protocol-number |
protocol-type [bit]} {source mask | any | host ip-address}{destination mask | any | host
ip-address}
● number is the number in sequence to initiate this rule
● ip-address is the Forwarding router’s address
● tunnel is used to configure the tunnel settings
● tunnel-id is used to redirect the traffic
● track <obj-id> is used to track the object-id
● track is to enable the tracking
● FORMAT: A.B.C.D
● FORMAT: slot/port
● ip-protocol-number or protocol-type is the type of protocol to be redirected
● FORMAT: 0-255 for IP protocol number, or enter protocol type
● source ip-address or any or host ip-address is the Source’s IP address
● FORMAT: A.B.C.D/NN, or ANY or HOST IP address
● destination ip-address or any or host ip-address is the Destination’s IP address
● FORMAT: A.B.C.D/NN, or ANY or HOST IP address
To delete a rule, use the no redirect command.
The redirect rule supports Non-contiguous bitmasks for PBR in the Destination router IP address
The following example shows how to create a rule for a redirect list by configuring:
Policy-based Routing (PBR)
571