API Guide

129024 0 0 0
DSAGT: 2 -> EVENTLOGAGENT: 5 0 0
129024 1 0 0
---------- More ----------
show processes ipc flow-control
Display Single Window Protocol Queue (SWPQ) statistics.
C9000 Series
Syntax
show processes ipc flow-control [cp | lp | pe | rp {slot-id | all}]
Parameters
cp Enter the keyword cp to view SWPQ statistics for the Control Processor CPU.
lp slot-id Enter the slot ID of the line card for which you want to view IPC message statistics. The
range of switch slot IDs is from 0 to 11. Enter linecard all to view IPC statistics for
all line cards.
pe pe-id Enter the keyword pe to view IPC message statistics on the port extender (PE) .The PE
ID range is from 0 to 255.
NOTE: The pe option is only visible when the feature extended bridge is
enabled.
rp Enter the keyword rp to view SWPQ statistics for the Route Processor CPU.
Defaults Display SWPQ statistics on all switch CPUs (Control Processor, Route Processor, and line cards).
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9 (0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and E-Series.
Usage Information
Field Description
Source QID /Tx
Process
Source Service Identifier
Destination
QID/Rx Process
Destination Service Identifier
Cur Len Current number of messages enqueued
High Mark Highest number of packets in the queue at any time
Timeout Timeout count
122 Control and Monitoring