API Guide

PIM-Sparse Mode (PIM-SM)
The protocol-independent multicast sparse-mode (PIM-SM) commands in this section are supported in the Dell Networking operating
system.
Topics:
• IPv4 PIM-Sparse Mode Commands
• IPv6 PIM-Sparse Mode Commands
IPv4 PIM-Sparse Mode Commands
The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.
clear ip pim rp-mapping
The bootstrap router (BSR) feature uses this command to remove all or particular rendezvous point (RP) advertisement.
C9000 Series
Syntax
clear ip pim rp-mapping [rp-address]
Parameters
rp-address (OPTIONAL) Enter the RP address in dotted decimal format (A.B.C.D).
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
Usage Information This command re-applies the RP mapping logic for all the groups learnt by the node. Any stale information
corresponding to the existing mapping configuration is updated. As a result, the existing BSR cache and the *,G's
are deleted only if these entries are stale.
44
PIM-Sparse Mode (PIM-SM) 1249